The Autel EVO Lite Intelligent Flight Battery is a spare or replacement battery for the EVO Lite series of drones from Autel Robotics. The EVO Lite Battery boasts up to 40 minutes of flight time thanks to its 6,175mAh, 11.13v lithium polymer battery technology. This added flight time is about 30 percent more than the competition.
EVO Lite Series Aircraft Batteries
- Disconnect button
- Battery level indicator
- Power button
Warning
- Only the battery and charger provided by Autel Robotics are allowed. Neither modifybattery and its charger nor use replace them with the third party equipment.
- The electrolyte in the battery has strong corrosion. If the electrolyte accidentally touches your eye or skin, immediately rinse with clear water and timely see a doctor
Autel EVO Lite Battery Use
-
Check battery level
The battery indicator is divided into LED 1, LED 2, LED 3, LED 4. The position of each indicator is shown in the figure below.
When the battery is turned off, press the power button for 1 second and then release it quickly to check the battery level. LED will indicate the current battery level, as shown below.
-
Turn on battery
The battery shall be turned off before it is installed. After installation, long press the power button for 3 seconds. The battery level indicator will indicate the current battery level.
-
Turn off battery
Long press the power button for 3 seconds to turn off battery. If the battery has been installed on aircraft, LED 1 and LED 4 will flash for five times to remind the shutting down. After all battery level indicators are turned off, take the battery out of the aircraft.
Install EVO Lite series aircraft battery
- Turn off the battery power switch before installing battery
- Insert the battery compartment and push it to the bottom, as shown below. There will be clicking sound when the battery is installed in place
Disassemble Autel Lite aircraft battery
- Turn off the aircraft battery power switch before taking out the battery
- Press the buckles at two sides of battery and slowly take out the battery.
EVO Lite Series Battery Charge
The aircraft battery and remote controller can use the charger and cable provided for charging. Before each use, the battery shall be fully charged.
- Connect the adapter to AC power
- Press and hold the disconnect button on both ends of the battery, and connect one end of the charging cable to the charging slot of the aircraft battery
- Under the charging state, the aircraft battery level indicator will flash circularly
- When all battery level indicators are off, this shows that the intelligent aircraft battery has been fully charged. Please take off the charger to complete charging
Intelligent EVO Lite Series Battery Functions
The following advanced functions can protect and prolong the battery service life.
- Self-discharge protection - if the battery is stored in high temperature environment or it is not used for 6 days and the battery level is high, the self-discharge protection will be activated. The battery will automatically discharge to a safe level, and this discharging process takes 2~3 days. In this period, it is normal that the battery may be slightly hot.
- Low battery protection - in the case of low battery level, the battery will automatically enter sleep mode to avoid damage. Under this mode, there will be no reaction when pressing the power button. To wake up the battery, it is allowed to connect it with charger.
- Charging temperature protection - the battery will stop charging in the case of charging temperature lower than 5ºC (41ºF) or higher than 45ºC (113ºF).
- Overcurrent protection - the large charging current will seriously damage the battery, so the battery will stop charging in the case of excessive charging current.
- Overcharge protection - the battery will automatically stop charging after it is fully charged
- Balanced protection - each battery unit shall maintain voltage balance to avoid overcharge or overdischarg
Battery Specification
Capacity | 6175mAh |
Nominal voltage | 11.13V |
Max charging voltage | 12.75V |
Battery Type | Li-Po 3S |
Energy | 68.7Wh |
Charging ambient temperature | 5~45℃ |
Maximum charging power | 78W |
Single battery charging time | 90min |
Weight | 306.5g |
Size | 115*58*49.5(L*W*H)mm |